Product Description

Enables orientation adjustment of terminal components in lens sleeve systems
Adjust the orientation of threaded assemblies by rotation to align the upper and lower components
360° continuous rotation, locked in the desired position with the side thumb screw
SM1 (1.035”-40) external thread
Sleeve height: 24mm

The SA-PL allows for quick orientation adjustment of terminal-mounted components in the system, and is commonly used to align the orientation of the upper and lower parts of threaded components when tightened. The sleeve corrects the orientation of threaded components via 360° continuous rotation, and can be locked in the desired position with the side thumb screw.

Model	SA-PL
Specification	Ø35.0*35mm
Light Through-hole Diameter	Ø18.5mm
Sleeve Body Height	24mm
Thread Type	SM1 (1.035”-40) external thread
Weight	49.3g
Material	7075 Aluminum Alloy

Technical Description

(1) The SA-PL enables rapid orientation adjustment of terminal-mounted components in the system, and is frequently used to align the upper and lower orientations of threaded components during tightening. Normally, the orientation of a threaded assembly may be skewed when fully tightened, resulting in misalignment between the upper and lower components. This sleeve corrects the orientation of threaded components through 360° continuous rotation, and can be locked in the desired position with the side thumb screw.

(2) The thumb knob in the middle of the positioning sleeve facilitates quick connection and disconnection of threaded components. Both the upper and lower parts are equipped with SM1 (1.035”-40) external thread sections and are installed via dovetail joint. During operation, connect mechanical parts to the upper and lower sections respectively; with the thumb knob loosened, rotate the component block mounted on the upper end to the desired position and tighten the knob to secure.